iWave Systems partnered with SoC-e for enabling HSR/PRP IP on iWave's Zynq 7000 SoC SOM Module. iWave has rigorously validated SoC-e's High-availability Seamless Redundancy (HSR) and Parallel Redundancy Protocol (PRP) IP Protocol on our Zynq 7000 SoC based SOM module. iWave's Zynq 7000 SoC SOM and SoC-e's HSR/PRP Switch IP Core provide the way to reduce the time-to-market, minimalistic design, simplifying the design complexity with longevity support.
SOC-e is pioneered company which develops IP portfolios for leading-edge networking and synchronization technologies for time critical systems. iWave Systems is an embedded solution offering company provides highly integrated, high performance, low power off the shelf System on modules for wide range of embedded applications.
Zynq-7000 programmable SoC family integrates the software programmability of an ARMŽ-based processor with the hardware programmability of an FPGA, enabling key analytics and hardware acceleration while integrating CPU, DSP, ASSP, and mixed signal functionality on a single device. The iW-RainboW-G28M (Zynq 7000 Board) is a featured-full and ready to-operate embedded software and advanced circuit development kit worked around the smallest member from the Xilinx Zynq-7000 family, the Z-7010.
The Zynq-7000 SOM / Development Kit is based on the Xilinx All Programmable System-on-Chip architecture, which firmly incorporates a single / Dual Cortex A9 @ with Xilinx 7-series field programmable gate array (FPGA) logic. At the point when combined with the rich set of media and connectivity peripherals accessible on the Zynq 7000 SOM, the Zynq Z-7007S, Z-7014S, Z-7010, Z-7020, can host an entire design system.
Memories, 512MB DDR3 (Expandable to 1GB) or 512MB NAND Flash (Expandable), that are on-board, video and sound I/O, USB 2.0 OTG, Gigabit Ethernet and SD (4bit) will have your board up-and-running with no extra hardware required. Moreover, PMIC with RTC bolster connectors is accessible to put any design on a simple development way.
The iW-RainboW-G28M gives an ultra-cost to embedded designers that don't require the high-thickness I/O of the FMC connector yet at the same time wish to use the enormous preparing force and extensibility of the Zynq AP SoC architecture.
For more information, visit: https://www.iwavesystems.com/zynq-7000-soc-som